Fuso Canter 2015, Руководство пользователя, Страница: 268 / 520

12-25
1.2 Adding oil
1. On Crew-cab models, the engine access open-
ing is located under the assistant driver’s seat.
Clean the area around oil filler cap to prevent
dust and dirt from entering the engine.
2. Remove the oil filler cap and add oil as neces-
sary.
3. Make sure that the oil level is correct. If the oil
level is checked immediately after adding, the
reading may be lower than the actual level
because all added oil may have not yet reached
the oil pan. Wait for at least 5 minutes after add-
ing oil and then check the oil level with the oil
level gauge . If you add too much oil, remove
oil through the drain plug on the oil pan to
achieve the correct level.
4. Install the oil filler cap.
CAUTION
•
The added oil should be of the same grade
and viscosity as the oil originally placed in
the engine.
•
Take care not to add more than the specified
quantity of oil. The engine can be severely
damaged if the correct engine oil level is not
maintained.
•
When adding engine oil, take care not to spill
it.
If oil is spilled on a belt, the belt will slip on
pulleys.
1.3 Replacement
NOTE:
You must reset the engine control unit every time
after replacing the engine oil. See 1.4 “Resetting the
engine control unit” for details of the method. If you
cannot do it yourself, have it done by an authorized
dealer.
1. Clean the surfaces around the oil filler cap
and remove the oil filler cap.
WARNING
Take care not to spill engine oil as engine oil
on the exhaust manifold or other hot sec-
tions of engine could catch fire. Wipe clean
the oil if spilt.
Z21277
Z21277
FE_FG.book Page 25 Wednesday, December 4, 2013 2:10 PM