Furuno TZT16F, Руководство по установке

Страница: 24 / 67

1. MOUNTING
1-16
5. Using the vertical adjustment space on
the bracket slots, slide the sensor up or
down to provide a projection of 3 mm
(1/8”). Tighten the screws.
How to attach the sensor to the bracket
1. If the retaining cover near the top of the brack-
et is closed, open it by depressing the latch
and rotating the cover downward.
2. Insert the sensor's pivot arms into the slots
near the top of the bracket.
3. Maintain pressure until the pivot arms click
into place.
4. Rotate the sensor downward until the bottom
snaps into the bracket.
5. Close the retaining cover to prevent the
accidental release of the sensor when your
boat is underway.
How to route the cable
Route the sensor cable over the transom, through
a drain hole, or through a new hole drilled in the transom above the waterline. If a hole
must be drilled, choose a location well above the waterline. Check for obstructions
such as trim tabs, pumps, or wiring inside the hull. Mark the location with a pencil. Drill
a hole through the transom using a 19 mm or 3/4” bit (to accommodate the connector).
Always wear safety goggles and a dust mask.
1. Route the cable over or through the transom. On the outside of the hull secure the
cable against the transom using the cable clamps. Position a cable clamp 50 mm
(2") above the bracket and mark the mounting hole with a pencil.
2. Position the second cable clamp halfway between the first clamp and the cable
hole. Mark this mounting hole.
Cable cover
Cable clamp
50 mm (2")
Hull projection 3 mm (1/8")
Step 1
Step 2
Step 3
Step 4
Latch
Pivot
arm
Slot
Retaining
cover
CAUTION
Never cut the cable; this will void the warranty.