Furuno RC-1500-1T, Руководство оператора

Страница: 224 / 418

7-4
6. Press the [ ] key to advance the cursor to Mode. Select the
communication mode, AUTO, ARQ or FEC.
7. Press the [ ] key to advance the cursor to Auto Search. Turn
Auto Search ON or OFF;
Auto Search ON: Radio stops scanning when it finds the stron-
gest (S/N ratio) free-signal frequency. Use it where signal propa-
gation in poor.
Auto Search OFF: Scanning starts and stops with the first-
received free-signal frequency. Normally, use this position.
8. Press [ ] to place the cursor on the No. 1 line. Enter channel or
user channel. See the table on the next page for MARITEX
radio channel information. Then, press the [ ] key to select
"Scan".
9. Press [ ] to advance the cursor to the No. 2 line. Enter channel
number. Repeat this procedure for other channels, up to 20.
10. Press the [Enter] key.
11. Press the [Enter] key again to register scan group.
Create
Change
Scan Entry
Scanning Group List
Scanning Set Up
Group Name : MARITEX-A
Ch Dwell Time : 4.5 sec (2.7-4.5 sec)
Mode : AUTO ARQ FEC
Auto Search : OFF ON
No Channel Rx Freq Tx Freq Pass/Scan
1 1
2 2
3 3
4 4
5 5
6 6
4268.60
6460.00
8556.00
12818.00
17024.00
22607.00
4203.50
6302.00
8398.50
12563.50
16790.50
22352.00
Pass/Scan
Pass/Scan
Pass/Scan
Pass/Scan
Pass/Scan
Pass/Scan
▼
MARITEX-A
Figure 7-3 Scan entry screen
To enter another scan group, select Create and then press the [En-
ter] key. Repeat steps 3 – 9.