Furuno GS-100, Руководство оператора, Страница: 62 / 157

6. BERTHING DISPLAY
6-8
6.4.2 How to pre-set ranges
The berthing display has a total of 11 ranges. Select the ranges to use, following the
procedure shown below. A minimum of one range must be turned on.
1. Press the MENU ESC key to open the menu.
2. Select [Scale Set Up] then press the ENT key.
3. Select [Range] then press the ENT key.
4. Select a range then press the ENT key. Show "X"
in a check box to select the range, or remove the
"X" to deselect the range.
5. Press T to show and select [Save] then press the
ENT key.
Note: If all ranges are turned off, the message "No
item be selected." appears. Select at least one
range.
6. Press the DISP key to close the menu.
6.5 Track
You can show past track or predicted track, or both past and predicted tracks on the
display using the speed data.
6.5.1 Types of tracks
Two types of track are available: past and predicted.
Past track
The past track can be shown with a solid line or both solid line and past ship markers.
Solid line: There are two types of past track: reference position track and stern track.
The reference position track is green (ground tracking) or blue (water tracking), and
the stern track is black. The tracks of the past five minutes are shown.
Past ship markers: A past track marker is added every 30 seconds. The markers are
colored light blue for water tracking, and light green for ground tracking. The last five
minutes of past track markers are shown.
You can select the type of past track to show from the menu. See paragraph 6.5.3 for
the procedure.