Furuno FS-1503, Руководство по обслуживанию

Страница: 40 / 136

2-33
4. THROUGH Signal
The antenna coupler control depends on the system setting 9921 ("through"-signal of an-
tenna coupler). The through-signal brings the characteristics of the matching circuit to a
through condition, and is not a static H or L signal but pulse signal.
The through-signal turns OFF the relay for controlling the coils K3, K7, and K10, turns
ON the relay for other coils, turns OFF the relays K13 to K22 for controlling the capaci-
tors, and makes the frequency characteristics of the antenna coupler flat by adding L1, L5,
and L8 in the line between TX IN/RX OUT and the antenna terminal.
System setting: 9921
0: sets to "through" in the following receiving conditions. (THRU not always)
1. MF: frequencies in transmitting and receiving are different.
2. HF: bands in transmitting and receiving are different. (1.2 MHz or more)
3. Receiving in scanning and sweeping modes.
4. Receiving frequency is less than 1605 kHz.
1: always sets to "through". (THRU always)
Table 2-7 "Through" Operation
System Setting
9921
Condition
THROU
Signal
Remarks
Same TX/RX frequencies. No
At power on
Different TX/RX frequencies. Yes 1
Changing RX frequency Switched to different frequencies. Yes 1
TX/RX under non-thru
condition In TUNE mode, switching between TX
and RX.
No 2
End of TUNE 2
TX/RX under thru con-
dition
After TUNE, start and end of TX.
Yes
1
End of TUNE ERROR
THRU not
always
Under TUNE ERROR
After TUNE ERROR, start and end of
TX.
No
Same TX/RX frequencies. 1
At power on
Different TX/RX frequencies.
Yes
1
Changing RX frequency No 1
End of TUNE 2
TX/RX under thru con-
dition
After TUNE, start and end of TX.
Yes
2
End of TUNE ERROR
THRU always
Under TUNE ERROR
After TUNE ERROR, start and end of
TX.
No
Remark)
1) The different frequencies mean the transmitting and receiving frequencies in the
"through" condition "0" of the system setting 9921.
2) Refer to above system setting: 9921.