Furuno FELCOM19 Inmarsat Mini-C MES, Руководство по установке

Страница: 12 / 51

2. WIRING
2-2
2.1 Antenna Cable Connector at the Communication
Unit
2.1.1 Antenna cable TP5FBAW-5DFB (30 m)
How to fabricate antenna cable 5D-FB-CV-NP
30
Cover with heat-shrink tubing and heat.
Outer Sheath
Armor
15
Nut
Gasket
Clamp
Inner Sheath
Braided Shield
5
Washer
50
Cut braided shield here.
3.5
Insulator
Core
Center Pin
Solder here.
Ring
Insulator Ring
Shell
Nut
Remove the outer sheath, armor and inner-
sheath by the dimensions shown.
Set the nut, washer, gasket, clamp onto
cable as shown.
- Be careful not to damage the braided
shield.
Fold back the braided shield onto the clamp
and trim the shield as shown.
Make the length of insulator 3.5 mm and the
length of the core 5 mm.
- Be careful not to damage the core.
Set the center pin to the core and solder the
pin from the hole in the pin.
(Pull the pin with approx. 1 kg of force to
check strength of solder joint.)
- Be sure the solder is flush with surface of
pin.
- Be sure there is no gap between center
pin and insulator. Do not push the center pin
into the insulator.
- Do the soldering as quickly as possible so
as not to deform the insulator.
Set the ring and insulator ring onto the
cable.
Set the shell to the cable then turn the nut to
tighten. (Do not tighten by turning shell.) -
Use a wrench or the like to tighten the nut
securely.