Furuno FCV-295, Руководство по установке

Страница: 19 / 40

10
6. Press T to select "Transducer" and then press the ENTER key. The list of programmed trans-
ducers appears.
7. Press T to S select transducer connected and then press the ENTER key.
8. Jot down the alphabet which appears on the "Tap" line. You may need to change the tap set-
ting at the rear of the display unit depending on the transducer type which is connected. For
details, see below.
9. If a low frequency transducer is fitted, repeat steps 2 to 8.
Note: Leave the "Tx Power" setting at "Auto".
10.Press and hold down the [ / BRILL ] key to turn off the power.
Tap setting
You may need to change the tap setting at the rear of the display unit depending on the transducer
type connected. Set the tap according to the alphabet shown when you selected transducer type.
200B-5S
50/200-1T
50/200-1ST
200B-8B
200B-12H
(Example: 200 kHz)
CAUTION CAUTION
Turn off the unit to change the tap
setting.
Malfunction or electrical shock can result.
Display unit rear panel
(connector cover removed)
Tap setting connector
(for high frequency)
E D C B A
Common
line
Tap setting connector
(for low frequency)
Set this end in applicable
slot according to
alphabet indication. Jumper
line