Furuno FAR-3230S-BB, Руководство по установке

Страница: 25 / 139

1. INSTALLATION
1-13
1.5.2 How to install the processor unit
Use four bolts (M6, local supply) to fix the processor unit.
1. Use 10 binding head screws (M4
×
8, supplied) to attach the chassis bases 1 and
2 to the processor unit.
Note: For bulkhead mounting, attach the chassis base 2 so that the notches on it
are facing the deck.
2. Use six bolts (M6, local supply) to fix the processor unit.
1.6 Sensor Adapter MC-3000S/3010A/3020D/3030D
(option)
Installation considerations
When you select a mounting location, keep in mind the following points:
• Locate the adapter away from heat sources because of heat that can build up inside
the cabinet.
• The vibration must be minimal.
• Locate the equipment away from places subject to water splash and rain.
• Be sure to connect the ground wire (between the earth terminal on chassis and the
ship’s earth).
• Leave sufficient space at the sides and rear of the unit to facilitate maintenance.
• A magnetic compass will be affected if the adapter is placed too close to the mag-
netic compass. Observe the compass safe distances in the "SAFETY INSTRUC-
TIONS" (on page i) to prevent interference to a magnetic compass.
• For MC-3000S, use a Cat5 cable of correspondence.
Chassis base 1
Chassis base 2
Notch
Notch
: Bolt holes
Notch