Furuno AT-1575, Инструкция по замене

Страница: 3 / 12

3
13. Use a cutter to remove the double-sided tape on Clamp 3, then remove the clamp.
14. Unfasten the hex-nut with a spanner.
15. Fix the new clamp to the location indicated in the figure below. Use the double-sided tape
attached to the clamp to secure the clamp in place.
16. Use the hex-nut removed at step 14 secure the fixing plate. Recommended fastening torque
is 2.2 Nm.
17. Unfasten the washer head screw (M4x15) and the wire assembly (Type AF) from the right
side of the ground plate.
18. Fasten the wire assembly (Type AF, Supplied and Installed) together with
washer head screw removed on step 17. Recommended fastening torque is 1.47Nm.
Hex-nut
Clamp3
Fixing Plate
Hex-nut
Clamp3
Washer
head screw
Wire assembly
(Type AF)
Approx. 30°