This quick start guide will help you install and use the device properly.
For further support please visit
www.furrion.com/support
.
WHAT’S IN THE BOX
Warranty Manual
Warning Card
Quick Start Guide
Warranty Manual
Warning Card
Quick Start Guide
Control Box x 1
QSG x 1
Warranty Manual x 1
NOTE:
Product design and packaging may change without notice.
INSTALLATION
WARNING
Risk of Electric Shock
Always verify that the electrical power to the circuit has been
disconnected before performing the installation procedures.
Wire Connection
Familiarize yourself with the controller and wire harnesses.
Wall Thermostat Cable
(4-wire harness)
Furnace Cable (2-wire)
12V DC Power Cable (2-wire)
Freeze Sensor Cable (wire with
copper tip and blue plastic clip)
1. Loosen the cable clamp on top of the control box and remove the
compartment cover. Pass the 115VAC power cord through the cable
clamp hole and make wire connections following the below color
codes:
– Black - Hot
– White - Neutral
– Green/yellow - Ground
2. Fit all cables into the cable
compartment and tuck any excess
wires up out of the way. Re-tighten
the cable clamp, do not over tighten.
Replace the cover.
Cable Clamp
SINGLE ZONE CONTROLLER
MODEL: FACC10SA-BL
FACC10ESSA-BL
QUICK START GUIDE
