Furrion DV3050, Инструкция по эксплуатации

Страница: 6 / 16

PAGE 4
Radio Operation
1. FREQUENCY SELECT
In RADIO mode. Press and hold PLAY/PAUSE button for about 5 seconds to
select your desired frequency EUROPE, USA1, USA2 or AUSTRALIA.
2. AM/FM BUTTON
In RADIO mode, press and hold INPUT MODE button on the front panel or briefly press
BAND
button on the remote control to select your desired radio band of FM1, FM2, FM3,
AM1, AM2, and the selected band will be displayed on the LCD of the front panel.
3. TUNE/SEEK UP/DOWN
In RADIO mode:
1) Press and hold or button on the front panel or press and hold
/ button on the remote control to automatically search down/up for a available
station from the current frequency.
2) Press or button on the front panel or press / button on
the remote control to manually search up or down with step by step for your desired station
from the current frequency.
4. APS BUTTON & SCAN BUTTON
In RADIO mode:
1) When pressing and holding
APS
button on the remote control or press and hold button on
the front panel, the radio searches from the lowest frequency and checks the signal strength level
until 1 cycle search is finished.And then the 6 strongest stations are preset to the corresponding preset
number memory bank. The AS operation is implemented in each bank of the selected band.
When the AS operation is finished, it will resume broadcasting
on the M1. (It can store 3x6 stations for FM and 2x6 stations for AM in all)
2) When briefly pressing APS button on the remote control or
press button on the front panel
,
the radio searches for each preset station from the M1. When the field strength level is more than
the threshold level of the stop level, the radio holds at that preset number for a few seconds with
releasing mute, and then searches again.
After finishing a circle of searching, it will stop searching on the M1.
NOTE: In FM band, FM1, FM2, FM3 are checked one at a time.
In AM band, AM1, AM2 are checked one at a time.
3) Press the SCAN button on the remote control to scan the radio frequency. If a valid signal has detected,
the current frequency will be hold and blinking for 5 seconds, then press SCAN again to stop and remain
the current frequency; otherwise, the radio will go on to scan the other radio frequency 5 seconds later.
5. PRESET STATION [ 1-6 ] BUTTONS
In RADIO mode:
1) To memorize the current frequency on the current band, press and hold any one of the six preset
buttons (1-6) .
2) To recall the preset memory on the current band, press one of the preset buttons [1-6] .
6. STEREO/MONO BUTTON
Press ST button on the remote control to select the STEREO or MONO sound mode for
FM band.
CCD-0005532 | REV DATE: 11.29.22