Furnware TOUCH ME FW, Руководство по установке

Страница: 7 / 7

INSTALLATION MANUAL EN
automatically carries out a sensitivity test which is memorised. The
adjustment test can last even up to 20 seconds during which the device
cannot be used. A series of flashes of the TOUCH ME luminous LED
confirm the end of the test and the availability of the device for use.
Any change of installation to a different location requires a device reset
which requires power to be removed from it for at least 10 seconds.
- ON-OFF Function. Switching on and off of the lighting devices
connected to TOUCH ME FW takes place through a brief contact of the
hand with the luminous diode.
- DIMMER and LEVEL MEMORY Function. With a prolonged touch of the
hand on the TOUCH ME FW luminous LED the brightness intensity of
the lighting devices connected to it can be adjusted (DIMMER); during
adjustment of the brightness intensity a brief flashing of the device
connected to
TOUCH ME FW indicates that it has reach maximum
brightness. The selected brightness level will be memorised until the
next adjustment (LEVEL MEMORY).
- TOUCH ME FW is provided with function "night-light" that means a
signalling light of the TLD that is activated only when the LEDs are off.
With normal or high light environment, the TLD issues a little light,
while with low or null light environment the TLD issues a more intense
light. During the operation of the LEDs, the light issued by the TLD will
be proportional to the regulation selected for them.
The function "night-light" can be disconnected or inserted with a long
touch on the TLD of 15 seconds, at the end of which the disconnection
of the function will be indicated with 2 little flashes, or the insertion
from 3 fast flashes.
- AUTO OFF Function. TOUCH ME FW has a safety feature (AUTO OFF)
which automatically switches off the lighting devices connected to it
after 18 hours of continuous operation.
WARNING
- If the external flexible cables of this device are damaged they must be
replaced by the manufacturer or a service centre authorised by the
manufacturer.
- TOUCH ME FW must be connected directly to a 12Vdc or 24Vdc
stabilised voltage safe power supply (sold separately) and must never
be connected to other electronic switches or DIMMERS of any type.
Connection of
TOUCH ME FW to a conventional mechanical switch for
household environments is not recommended in order to prevent
TOUCH ME FW from carrying out the AUTO TEST function at each
activation (ON) of these switches.
- TOUCH ME FW must not be installed near heat sources, in the vicinity
of electromagnetic fields or exposed directly to light sources that could
alter or compromise operation.
WARRANTY
The warranty on the device is valid only if powered by a power supply
provided by DOMUS Line. The warranty general terms and conditions
for this device are available at
www.domusline.com