1
8CRI
XXX
CARE AND MAINTENANCE
Glass Care Instruction
The g
lass used
on this product
is tempered for your safety.
Remove liquids or other spills immediately.
Regularly wipe over with a soft clean cloth, ensuring sharp and abrasive material is removed prior.
Lightly dampen cloth with clean water if required.
Proprietory g
lass cleaning product
s
can be used
but surrounding
metal or powdercoated metal
surfaces must be wiped over
with clean water to
remove glass cleaner residual to avoid damag
e.
Lacquer and Paint Surfaces Care Instruction
Remove liquids and other spills immediately.
Do not use abrasives or chemical cleaners.
Do not rub hard or excessively.
Regularly wipe over with a
soft clean cloth
, preferably microfibre, ensuring abrasive or sharp
material has been removed prior.
Dampen the cloth with clean water to remove light soiling that cannot be dusted off.
Proprietory cleaners that are pH neutral and non-abrasive or chemically aggressive can be used to
remove grease and grime
.
Seek professional advice if you are not sure of cleaning agent suitability.
Use of polishing products is not recommended.
Powdercoated and Stainless Steel Care Instructions
Remove liquids and other spills immediately.
Do not use abrasives or chemical cleaners.
Do not rub hard or excessively.
Regularly wipe over with a soft clean cloth, preferably microfibre, ensuring abrasive or sharp material
has been removed prior.
Dampen the cloth with clean water to remove light soiling that cannot be dusted off.
Do Not:
• Expose to direct sunlight, intensive heat, and weather or soak unnecessarily. Always avoid excessive
hard rubbing
• Use saddle soap, detergents, solvents, abrasives, unidentified cleaners, or any products containing
silicon or solvents
Please refer to safety warning and advice section for use.
E
very 6 months a
ll bolts
and
screws should be checked and
re-
tighten as
required.
Caution
:
D
o not overtighten.
Regularly
check
a
ll
visible
metal
components
such as legs or
glass top support rails
for scratches or
dents
and t
ouch up with suitable colour paint.
Expose
d
metal will
o
xid
ise
(rust)
unless touched up,
particulaly in seaside locations.
Stainless steel can show signs of surface oxidization. Wipe over with a soft cloth to remove and lightly
spray with protective oil if necessary.
General
Care Instructions
Page 3 of 5