10
Alarm:
Warning by buzzer and display RSSI LOW on the screen when signal lower than
the configured level.
The options are as follows:
None, 20%, 35%
and
50%.
Quad Finder
In case your drone gets lost while flying. The Graphic interface will point in the right
direction and guide you to the place where it fell down with a buzzer warning
(Beeper) and RSSI level (RSSI Graph). However, the function only work when your
quad (VTx) is still working after crashed.
Hold
Mode
buttton to turn off buzzer
Calibration
Why do we need to calibrate the True-D?
A Diversity receiver system is two receivers built into a single package, allowing the pilot
to choose two different antenna systems for maximum levels of video range & clarity.
With two receivers used by the diversity algorithm, you need to get accurate numbers
between the two individual modules for calculation of the best video signal in the
goggles.
Note:
when you update new firmware, you have to recalibrate your True-D.
How to do I calibrate the True-D diversity module?
Step 1: Remove all antennas on True-D and plug it into the goggles.
Note:
Verify that all pins on True-D are correct when plugged in the goggles.
Step 2: Plug Battery and verify that
Turned On
Rx Switch in the goggles.
Step 3: Turn on your VTX.
Step 4: Press
Mode
button to open the navigation menu.
