6
SECTION 3: CHARGING THE WIRELESS KEYPAD
The wireless keypad contains a rechargeable battery. While the charge of the keypad battery will typically
last between 1 to 2 weeks (depending on usage), we recommend charging your keypad the night before
each use of the scoreboard.
The charging indicator will light up orange to indicate the keypad is charging. The light will turn green
once the keypad is fully charged.
Plug keypad charger into 120VAC wall outlet
SECTION 4: PAIRING THE SCOREBOARD AND KEYPAD
1. Cycle the scoreboard power off and on (waiting 3
seconds before each turn-on) until the scoreboard is
displaying the keypad RF connection screen shown
below at right. Make certain only one scoreboard in
the vicinity is showing this display at any given time,
otherwise the pairing process will fail.
RF connection screen
2.
Press and hold the
button on the keypad for up to 10 seconds (until the keypad emits
a beep). The scoreboard will go through a process of reconnecting to the keypad and will respond
after a few seconds by displaying the radio channel number. The keypad will beep twice if the
connection is good, or 3 times if the connection failed. Repeat this step if necessary to establish a
connection.
3.
After a couple seconds the scoreboard will show a normal display and is then ready for action.
NOTE - For scoreboard models built after October 2015:
The wireless keypad must be cleared of any previous scoreboard connection data to allow it to
connect to the scoreboard again. To clear the keypad’s previous connection information, press
and hold the
and
buttons simultaneously until the keypad status light blinks
5 times.
