Funtime FT421CR, Инструкция по эксплуатации, Страница: 5 / 10

Operation Procedures
1. Make sure the popcorn maker is unplugged before you do any of the following.
Before using the unit, please check carefully if voltage is suitable to the country.
(Please check if the voltage is matching with rating label specified next to the power cord.)
2. Clean the internal surface of the kettle and main unit surfaces.
3. Main unit has 2 function switches as follows:
4. Hook up the kettle onto the hanger of the main unit.
5. Plug in the power cord to the popcorn maker.
6. Switch on the light and heater (I), then fill in suitable amount of butter
or oil (Fig. 1). Consumer could fill amount of oil (Max 15g) subject
to your own preference.
7. Kettle should be preheated for 3-4 minutes with oil until steam comes
out from the kettle. Prepare kernels with sugar. Measure amount of
kernels with measuring scoop providing. Amount of sugar subject to
your own preference. DO NOT USE liquid sugar and honey.
8. Open the lid and pour in pre-mixed kernel and sugar (Fig. 2)
CAUTION: Lid might be hot. Use an oven mitten.
9. Switch ON the Kettle Heater & Stirrer (II) so that it starts stirring (Fig. 3).
10. Close the door carefully.
11. Popcorn starts popping out through the lid after about
2 to 3 minutes. (Fig. 4)
12. Switch OFF the Kettle Heater & Stirrer (II) when popping completed
(No more popping sound from kettle). Rotate the roller bar of the kettle
and pour out all remaining popcorn from kettle.
13. Keep Kettle Heater (II) OFF if the unit is not continuously running.
Keep only the spot light and warmer (I) ON to keep the popcorn warm,
dry and tasty.
14. Serve your popcorn with popcorn scoop provided.
15. Remove plug from power supply if the unit is not being used for a long time.
16. Repeat steps 7 to 10 for continue popping.
(I) Spot Light and Warmer
(II) Kettle Heater and Stirrer
LIGHT
POP