Once you have successfully completed logging on your unit this is indicated by an acoustic signal followed after a few
seconds by this symbol
F
in the display of your handset.
If the message »
Subscription Failed
« appears in the display, acknowledge by pressing the OK button and
repeat the entire procedure.
Press the menu button to return to the handset’s idle state.
Logging on other handsets using the master handset
Before you can log on further handsets at the system you must first enter the serial numbers for these units into the
system. The serial number for the handset is located on the nameplate beneath the battery.
Perform the following steps on the master handset:
M
Press the menu key.
ˆ Profile
ˆ Setting
>
Use the arrow buttons to select the »
Servi-
ce
«menu (1x to the right).
ˆ Menu
ˆ ELMEG
O
Confirm your selection by pressing OK.
ˆ View
ˆ CLIP-Stack
ˆ <Enter>
<
Use the arrow buttons to select the
»
Read/Write - Userdata
« menu (2x to
the left).
ˆ Read/Write
ˆ Userdata
ˆ <Enter>
O
Confirm your selection by pressing OK. The se-
rial number for the master handset is then dis-
played on channel 0 (first handset).
ˆ Chan. 0
ˆ IPEI
ˆ012345678901
>
Use the arrow keys to select the channel for the
handset that you are logging on and enter the se-
rial number for that unit.
ˆ Chan. 1
ˆ IPEI
ˆ123456789012
O
Confirm your entries by pressing OK.
Now, enter the telephone number for the handset (internal number for PABX system). Z.B. »
41
«.
This MSN extension number is displayed when the handset is idle and is stored in the system’s telephone book.
Chan. 1
ˆ Localno.
ˆ41__________
Logging on the handsets at an elmeg DECT 300 system
6
