ATR833S / P/N 833S-(Cxxx)-(Cxxx)
Operation and Installation
36
Document-Nr.: 01.142.010.71e / Revision:1.03
4.4 Unpacking and Inspection of the Equipment
Carefully unpack the equipment. Damage due to transportation must be
reported to the shipping company immediately. Save the shipping
container and all packing materials to substantiate your claim.
4.5 Mounting
In cooperation with a maintenance shop, the location of the radio in
the cockpit and kind of the installation should be specified. The
maintenance shop could supply all cables but suitable sets of
cables are available also from f.u.n.k.e. AVIONICS GmbH.
Select a position away from heat sources. Care for adequate
convection cooling.
Leave sufficient space for the installation of cables and connectors.
Avoid sharp bends and wiring close to control cables.
Leave sufficient lead length for inspection or repair of the wiring of
the connector.
Bend the harness at the rear connectors such as to inhibit water
droplets (formed due to condensation) from collecting inside the
connector.
The equipment is fixed from the front with four 4x8mm screws into
a 2¼ ” cut-out.
For mounting details / drawing refer to chapter 4.11.2
Please use the original packing material for storage and
shipping.
