FUNAI TVD-A2104PT, Руководство по обслуживанию

Страница: 26 / 113

1-7-6 T6100EA
10. Sub-Brightness Adjustment
Purpose: To get proper brightness.
Symptom of Misadjustment: If Sub-Brightness is
incorrect, proper brightness cannot be obtained by
adjusting the Brightness Control.
Note: Bar (A) in Fig. 6 --- 0 IRE
1. Enter the service mode. (See page 1-7-1.)
Then input SYMPTE signal from RF (or Ext.) input
and leave it for at least 20 minutes.
2. Press [PICTURE] button. (Each time [PICTURE]
button is pressed, display will change BRT, CNT,
COL, TNT, and SHP in that order.) Select BRT and
press [CH
o
/
p
] buttons so that the bar (A) in Fig. 6
is just visible.
3. Turn the power off and on again.
11. Setting for CONTRAST,
COLOR, TINT and SHARP
Data Values
General
1. Enter the Service mode. (See page 1-7-1)
2. Press [PICTURE] button. (Each time [PICTURE]
button is pressed, display will change BRT, CNT,
COL, TNT, and SHP in that order.)
CONTRAST (CNT)
1. Press [PICTURE] button on the remote control
unit. Then select CNT display.
2. Press [CH
o
/
p
] buttons on the remote control unit
so that the value of "CONTRAST" (CNT) becomes
83.
COLOR (COL)
1. Press [PICTURE] button on the remote control
unit. Then select "COLOR" (COL) display.
2. Press [CH
o
/
p
] buttons on the remote control unit
so that the value of "COLOR" (COL) becomes 65.
TINT (TNT)
1. Press [PICTURE] button on the remote control
unit. Then select "TINT" (TNT) display.
2. Press [CH
o
/
p
] buttons on the remote control unit
so that the value of "TINT" (TNT) becomes 63.
SHARP (SHP)
1. Press [PICTURE] button on the remote control
unit. Then select "SHARP" (SHP) display.
2. Press [CH
o
/
p
] buttons on the remote control unit
and select "0."
Test point Adj. Point Mode Input
Screen
CH
o
/
p
buttons
RF
(or Ext.)
SYMPTE
Tape M. EQ. Spec.
---
Pattern
Generator
See below
Figure
Black
White
This bar
(A) just
visible
A B C
Fig. 6