FUNAI SYLVANA 6413TB, Руководство по обслуживанию

Страница: 29 / 69

CABINET DISASSEMBLY INSTRUCTIONS
1. Disassembly Flowchart
This flowchart indicates the disassembly steps for the
cabinet parts, and the CBA in order to gain access to
item(s) to be serviced. When reassembling, follow the
steps in reverse order. Bend, route and dress the cables
as they were.
Caution !
When removing the CRT, be sure to discharge the
Anode Lead of the CRT with the CRT Ground Wire
before removing the Anode Cap.
2. Disassembly Method
Step/
Loc. No.
Part
Removal
Fig.
No.
Remove/*unlock/
release/unplug/
unclamp/desolder
Note
[1]
Rear
Cabinet
1,2
4(S-1)
1
[2] CRT CBA 4,5 CN501 2
[3] Main CBA 3,5 CN571 3
[4] CRT 4 4(S-2), Anode Cap 4
↓ ↓ ↓ ↓ ↓
➀ ➁ ➂ ➃ ➄
Note :
➀
.
Order of steps in procedure. When reassembling,
follow the steps in reverse order.
These numbers are also used as the Identification
(location) No. of parts in figures.
➁
. Parts to be removed or installed.
➂
.
Fig. No. showing procedure of part location
➃
.
Identification of part to be removed, unhooked, un-
locked, released, unplugged, unclamped, or
desoldered.
S=Screw, P=Spring, L=Locking Tab, CN=Con-
nector, *=Unhook, Unlock, Release, Unplug, or
Desolder
2(S-2) = two Screws (S-2)
➄
.
Refer to the following "Reference Notes in the
Table."
Reference Notes in the Table
1. Removal of the Rear Cabinet. Remove screws
4(S-1), then slide the Rear Cabinet backward.
2. Removal of the CRT CBA. Disconnect CN501 then
pull the CRT CBA backward.
3. Removal of the Main CBA. Disconnect CN571 on
the Main CBA then slide the Main CBA backward.
Caution !
Discharge the Anode Lead of the CRT with the CRT
Ground Wire before removing the Anode Cap.
4. Removal of the CRT. Remove screws 4(S-2) and
Anode Cap. then slide the CRT backward.
[1] Rear Cabinet
[2] CRT CBA
[3] Main CBA
[4] CRT
4-1 L1300DC