PLEASE NOTE:
The required wheel size - minimum diameter of 16".
Recommended width of 8” with a 4.0” offset from the inward
side. Maximum recommended tire size-35”
This system is designed to reuse many of the factory
installed metric bolts and hardware, except where noted.
BEFORE YOU BEGIN:
Check the parts and hardware against the parts list to assure
that your kit is complete. Read the instructions and separate
the parts according to the area where they will be used on the
vehicle. Separating and placing the hardware with the brackets
before you begin will save installation time.
Always wear safety glasses when using power tools.
A Jeep Wrangler JK Factory Service manual will aide in the
installation of this kit.
DISASSEMBLY - FRONT
1.
Raise and support vehicle with jack stands. Support axle
with a floor jack. Remove wheels and tires.
2.
Working on one side of the vehicle, remove front shock
absorber. Disconnect and remove the sway bar link at the axle.
Leave the front sway bar attached at the frame/crossmember.
Sway bar link is shown in Fig.1
3.
Remove the front track bar from the vehicle. Save hardware.
Fig.2
4.
Lower axle until coil spring is free from upper mount.
Remove coil spring.
Fig.3
NOTE: Shock absorbers that are longer than factory are
required to perform this installation.
Fig.2
Fig.3
Fig.1
Pg.6
