Full Spectrum Laser Master Class CO2 Flatbed, Руководство пользователя

Страница: 8 / 33

The power supply is capable of releasing a current up to 20mA. This power is sent to the discharge terminals
on the laser tube itself. In order to prevent access to bare wiring your laser shipped with silicone terminal
covers. Please notify Full Spectrum Laser support and immediately cease operations if the covers ever slip
and expose bare wire.
● Do not open any of the machine’s access panels while the unit is
plugged in.
Opening a panel may expose the operator to the unit’s
power box, which is potentially lethal.
● Never make or break any electrical connections to the system
while the unit is turned on.
● Never access any electrical areas with hands or tools unless the
unit is disconnected from the power for at least one hour.
● Never replace the installed 20 amp fuse with one of a higher
rating.
This will void your warranty and the electronics will not be
adequately protected from surges or short circuits.
● POWER ON/OFF is controlled by the switch at the back of the
machine.
The machine is on when the (-) side is pressed and off when
the “o” side is.
● In case of a blown fuse always contact Technical Support before
replacing anything.
The standard for laser safety is the American Standard for the Safe Use of Lasers, Z136.12000. Developed by the American National
Standards Institute (ANSI) it is the basis for many federal regulations and Occupational Safety and Health Administration (OSHA) guidelines
for laser and laser system manufacturers. It contains detailed information concerning the proper installation and use of laser systems. While
the ANSI standard is not a law, its recommendations, including warning signage, training, and the designation of a laser safety officer, may be
mandatory under local regulations. It is the operator's responsibility to ensure that the installation and operation of the Full Spectrum Desktop
Laser System are performed following applicable laws. Copies of ANSI Standard Z136.12000 are available from:
LASER INSTITUTE OF AMERICA 12424 RESEARCH PARKWAY, SUITE 125 ORLANDO, FL 32826 (407) 3801553.
Electrical Safety
CAUTION!
CO2(150W) Max Thickness
Acrylic 20mm (25/64”)
Soft Wood 15mm (19/32”)
Plywood 12mm (1/2”)
Leather 6mm (1/4”)
Rubber 6mm (1/4”)
Materials
7