Connect Hand Programmer to battery or wall adapter. Use the Mode
Button to set the programmer to mA mode.
The programmer will toggle back and forth between I-SET and a mA
setting.
Press the READ Button to give an accurate reading of the current on
the Fulham Driver as it came from the factory. This can vary and 700
mA is shown as an example.
Use the Toggle Button to set the Fulham Driver to the desired current.
In this case 1000 mA is shown as an example.
Press the Program Button.
The programmer will flash the word “PROG”.
The Programmer will now toggle between “OK” and “1000mA” (example setting).
To confirm that you have set the current correctly, simply press the READ button and the display will
show the mA setting.
Your Fulham Driver is now programmed.
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
www.fulham.com • 12705 S. Van Ness Avenue, Hawthorne, CA 90250 • Tel: +1 (323) 599-5000 • Fax: +1 (323) 754-9060 • [email protected]
HarnesstheHorsepower
