Fulgor Milano FF 352 NF ED X L, Инструкция по установке и эксплуатации

Страница: 19 / 28

1169
19
Using the appliance
EN
CONTROL PANEL
1 ON/OFF
2 TEMPERATURE ADJUSTMENT
UP
DOWN
3 DISPLAY SCREEN
4 DOOR OPEN ALARM ON DISPLAY
5 SUPER FUNCTION
6 ALARM TEMPERATURE FUNCTION
IMPORTANT WARNING
Whenever the product has been lying horizontally during
transportation, it should be left to stand upright for at
least six hours before it is switched on, otherwise it may
be noisy when it is in operation.
NOTE: Before inserting the plug into the electri-
cal socket, ensure that the line voltage corresponds
with that indicated in the product data plate. Connect
the socket to the mains. Do not use adapters or
extension leads, as these may overheat and burn.
SWITCHING ON THE APPLIANCE
Open the door. The refrigerator start by pressing the
1 ON/OFF button for at least 0.5 seconds, followed
by an acoustic signal (1 BEEP): the display shows the
temperature set in the freezer compartment and flashes
for 6 seconds, then the actual temperature of the com-
partment appears. The display shows a temperature
range b20 and -40°C. If a temperature higher
than +20°C is detected, the display (3
) will show the “
H
”
symbol (steady light). After 30 seconds the appli ance starts
operating. The appliance shutdown occurs by pressing the
1 ON/OFF button for at least 5 seconds, followed by an
acoustic signal (
2 BEEP). At this point the display is off.
Horizontal dashes are displayed with the appliance
switched off on the display (3)
.
SETTING THE TEMPERATURE
The appliance has a standard setting suitable for normal
mode operation.
The temperature can be set between -14 °C and -24
°C. The temperature is set by pressing the 2 UP/DOWN
symbols, UP for higher values and DOWN for lower va-
lues. Upon starting the appliance, the display (3) shows
the actual temperature; it varies one degree at a time
whenever the 2 UP/DOWN symbols are slightly pressed;
during temperature setting, the displayed value flashes.
About 5 seconds after the last symbol has been pressed,
the actual temperature is displayed. The temperature
slowly reaches the set value.
ATTENTION! If the appliance is switched on
immediately after it has been switched off, the
compressor will start after 10 minutes. This is part
of the appliance normal operation.
NO-FROST
Technology