Fulgor Milano FBC 343 T NF ED, Инструкция по установке и эксплуатации

Страница: 28 / 32

1165
28
Cleaning - Electrical connection
1
3
2
V
R
EN
CLEANING
Before starting any cleaning, disconnect the
appliance from the mains electricity supply.
The protections (wire grill, covers) must not be
removed by unqualified personnel: do not use the
appliance if the protections have been removed.
WHEN CLEANING THE INTERNAL PLASTIC PARTS AND
THE DOOR GASKEt:
do not use abrasives or detergents of any kind.
- Use a warm solution of bicarbonate of soda (two
spoonfuls in two litres of water).
CLEANING THE CONDENSER
- This should be carried out at least twice a year.
- Clean using a domestic vacuum cleaner or a brush.
A dirty condenser will have a negative effect on the
appliance and reduce its performance.
FOR PROLONGED ABSENCES
- Empty the compartments.
- Disconnect the appliance from the mains electricity
supply.
- Clean both the compartments and dry them.
- Leave the doors open to prevent bad smells or mould
from forming.
CLEANING THE WATER DRAIN
When cleaning the condenser, check that the rear drain
pipe R is not blocked.
- Remove drain pipe R from the container V and if
necessary clean it.
CLEANING THE ANTIBACTERIAL FILTER
- Every 4 months.
1 Remove the filter-holder cover fig. 1.
2 Remove the filter fig. 2.
3 Wash it with hot water (it can be washed also in the
dishwasher); dry it at a temperature lower than 100°C;
to maintain a proper filtering capacity, replace the filter
every 2 years. Remount it in the specific seat and place
back the cover fig1.
POWER SUPPLY CABLE
- Periodically inspect the power cable to check its
condition.
- If the cable is damaged, do not use the appliance and
do not attempt any repairs. Call a qualified technician
to replace the faulty cable.
ELECTRICAL CONNECTION
Check that the mains voltage complies with that indicated on
the rating plate located on the bottom left of the compartment.
If the mains socket does not have an earth connection or if
the plug is not suitable for the mains supply system, refer to
a qualified electrician. Do not use adapters or extension leads,
as these may overheat and burn.