Fulgor Milano F4OTR30S1, Руководство по установке

Страница: 8 / 24

EN
8
Installation Guide
STEP 2 - DRILLING
Reference the Wall Template.
STEP 3 - TIGHTENING THE SCREWS
To attach the mounting plate to the wall using the toggle
bolt assemblies and/or lag screws:
• Insert toggle bolts through mounting plate at required
locations and add the spring loaded toggles. See
Figure 19.
Be sure you leave space at least the thickness of the wall
between the mounting plate and the end of the toggle
nut, (in closed position). If you do not leave this space,
the toggle nut will not open on the other side of the wall.
Figure 19
• Position mounting plate on wall and insert toggle bolt
assemblies through the drywall holes or start the lag
screw(s) through the wall stud(s). See Figure 20.
Dry Wall
Space more than
wall thickness
Figure 20
• Next, secure mounting plate to the wall by tightening
toggle bolt assemblies or lag screw(s). See Figure 21.
Figure 21
• Drill
3
/
16
” diameter lag screw hole(s), into one or more
wall studs.
(Remember, you must have at least one lag screw
secured to a wall stud.) For stud location refer to WALL
CONSTRUCTION, see page 3.
• Tighten the lag screw(s) into wall stud(s).
Mounting Oven to The Wall
NOTE: IT IS VERY IMPORTANT THAT THIS OVEN BE
INSTALLED BY TWO PEOPLE.
IMPORTANT: DO NOT GRIP OR USE HANDLE DURING
INSTALLATION.
Preparation of Top Cabinet
You need to drill holes for the top support screws and a hole
large enough for the power cord to fit through.
Read the instructions on the TOP CABINET TEMPLATE.
Tape it underneath the top cabinet.
Drill the holes, following the instructions on the template.
NOTE:
TOP CABINET TEMPLATE instruction must be installed
to proceed.
STEP 1
• Protect the top of your range by placing a portion of the
carton or some other heavy material over the cooking
surface before mounting your oven.
STEP 2
• Lift the microwave oven and tilt it forward.
• Hang the unit on two tabs at the bottom of the mounting
plate. See Figure 22.
Figure 22
1.TINSKB287MRR0_FULGOR OTR_F4OTR30S1_Install.indd 8 6/28/19 2:10 PM