En-2
Press the “
” button or “
” button to set
the room temperature while in operation. (The temperature
setting should be considered a standard value, and may differ
somewhat from the actual room temperature.)
TEMPERATURE
* A heat pump model that is not set up as a primary indoor
unit cannot operate in the AUTO modes.
** Fan cannot be selected for a heat pump model.
*** Heating operation cannot be performed in the cooling only
models.
• If the priority mode is set to “Priority on Primary indoor unit”,
the operating mode of other indoor units except the primary
indoor unit will be controlled by the primary indoor unit.
• If the operating mode of the primary indoor unit is set to “AUTO”,
“AUTO” is displayed in addition to the indicator of current
operating mode on other wired remote controllers except the
primary indoor unit. In this case, operation of other indoor units
is controlled by the primary indoor unit.
Ex.: When operating mode of the primary indoor unit is set to
“AUTO” while air conditioning setting.
(The indication on other wired
remote controllers except the
primary indoor unit).
OPERATION
(1) is displayed if there is an error.
Stop the operation immediately and contact the administrator.
(2) When a button is pushed to change a restricted setting,
will blink.
When
is displayed, there are functions for which settings cannot be made.
(3) When
is displayed, the air conditioner might not sufficiently cool the room in cooling mode,
or sufficiently heat the room in heating mode. If does not turn off after a while, contact the
administrator.
(4) The inoperative setting of the indoor unit cannot be set.
(5) •
is displayed when operation of the air conditioner has stopped due to an emergency.
•
is displayed when the air conditioner is in the test operation.
NOTES:
Press the “
” or “
” button to select the fan
speed while in operation. (The available fan speed differs depend
-
ing on the indoor unit.)
FAN SPEED
Press “
” button to select the operation mode while
in operation.
OPERATION MODE
When the primary indoor
unit is set to “AUTO”.
Each pressing of the “
” button changes operation and stop.
During in operation, the indicator lamp (green) is on.
START / STOP
Instructions on heating are not applicable for the cooling only models.
Temperature setting range
COOL/DRY/
AUTO*
18 to 30 °C (64 to 88 °F) or
20 to 30 °C (68 to 88 °F)
HEAT
VRF system: 10 to 30 °C (48 to 88 °F)
Other system: 16 to 30 °C (60 to 88 °F)
*
The lower limit of the setting temperature is different depending on the place of use.
(AUTO) (COOL)
(DRY)
(FAN)
(HEAT)
*
**
***
Press the “
” button to set the airflow direction or the
Swing mode.
AIRFLOW DIRECTION
Airflow direction indicator
(SWING)
(UP)
(DOWN)
* The fan speed is set automatically.
(AUTO)
*
(QUIET)
(LOW)
(HIGH)
Fan speed indicator
9373329763_OM_En_UTY-RSRYT.indd 2
9373329763_OM_En_UTY-RSRYT.indd 2
2021/05/13 13:30:30
2021/05/13 13:30:30
