12
11. TEST RUNNING
• Perform test operation and check items 1 and 2
below.
• For the operation method, refer to the operating
manual.
• The outdoor unit may not run, depending on the
room temperature. In this case, press the TEST
RUN button while the air conditioner is running.
(With the transmit section of the remote control unit
facing the body, press the TEST RUN button with
the tip of a ball point pen.)
• To end test operation, press the remote control unit
START/STOP button.
(When the air conditioner is run by pressing the
remote control unit TEST RUN button, the OPERA-
TION and TIMER Iamps will simultaneously flash
slowly.)
1. INDOOR UNIT
(1) Is operation of each button on the remote control
unit normal?
(2) Does each lamp light normally?
(3) Do not air flow direction flap and louvers operate
normally?
(4) Is the drain normal?
2. OUTDOOR UNIT
(1) Is there any abnormal noise and vibration during
operation?
(2) Will noise, wind, or drain water from the unit disturb
the neighbors?
(3) Is there any gas leakage?
A
B
START
STOP
C
D
Fig. 43
START/STOP button
TEST RUN button
14. REMOTE CONTROL UNIT lNSTALLATION
(1) Check that the indoor unit correctly
receives the signal from the remote
control unit, then install the remote
control unit holder.
(2) Select the remote control unit hold-
er selection site by paying careful
attention to the following:
Avoid places in direct sunlight.
Select a place that will not be affected
by the heat from a stove, etc.
1. REMOTE CONTORL UNIT HOLDER INSTALLATION
Install the remote control unit holder to a wall or pillar
with the tapping screws.
Fig. 44
Tapping
screws
Insert
Slide up
q
Mount the Holder.
w
Set the Remote
Control Unit.
e
To remove the
Remote Control
Unit (when use
at hand.)
For use as Wall Fixing Type
Tapping
screws
Insert
Slide
q
Mount the Holder.
w
Set the Remote
Control Unit.
e
Attach the unit
to the holder as
shown.
Tapping
screws
12. FINISHING
(1) Install the filter guide.
(2) Install the intake grilles.
(3) Install side covers A and B (if the unit is installed in a
half-concealed orientation, only install side cover A).
(4) Install the air filters.
13. CUSTOMER GUIDANCE
Explain the following to the customer in accordance
with the operating manual:
(1) Starting and stopping method, operation switching,
temperature adjustment, timer, air flow adjustment,
and other remote control unit operations.
(2) Air filter removal and cleaning.
(3) Give the operating and installation manuals to the
customer.
For use as Handy Type
