Powering On the System
57
Related Information
■
“To Examine the System for Faults” on page 57
■
Integrated Lights Out Manager (ILOM) 2.0 Supplement for SPARC Enterprise T5140
and T5240 Servers
■
Integrated Lights Out Manager (ILOM) 3.0 Supplement for SPARC Enterprise T5140
and T5240 Servers
■
SPARC Enterprise T5140 and T5240 Servers Administration Guide
▼
To Examine the System for Faults
1. Perform the following steps to verify that there are no faults:
a. Set the virtual keyswitch to
diag
mode so that POST will run in Service
mode.
b. To initiate the power on sequence, type the
start /SYS
command.
You will see an ILOM CLI alert message on the system console. This message
indicates that the system has reset.
0:1:0>Network Interface Unit Tests....Done
0:1:0>Functional CPU Tests....Done
0:1:0>Extended Memory Tests....Done
2007-12-14 16:45:28.800 0:1:0>INFO:
2007-12-14 16:45:28.806 0:1:0> POST Passed all devices.
2007-12-14 16:45:28.816 0:1:0>POST: Return to VBSC.
2007-12-14 16:45:28.824 0:1:0>Master set ACK for vbsc runpost
command and spin...
SPARC Enterprise T5240, No Keyboard
Copyright 2007 Sun Microsystems, Inc. All rights reserved.
OpenBoot 4.27.x, 3968 MB memory available, Serial #74409918.
Ethernet address 0:14:4f:6f:67:be, Host ID: 846f67be.
{0} ok
->
set /SYS keyswitch_state=diag
Set ’keyswitch_state’ to ’diag’
-> start /SYS
Are you sure you want to start /SYS (y/n)?
y
Содержание SPARC Enterprise T5140
