Fujitsu SPARC Enterprise T5120, Примечания к продукту

Страница: 87 / 150

Appendix A Fixed Issues 75
If the
dram-esr
is different, schedule a repair procedure to replace the affected
memory module. Use
fmdump -v -u
event_id to identify the module.
Ethernet Interface Related Issues
TABLE A-2 lists the Ethernet related issues that have been fixed.
TABLE A-2
Fixed Ethernet Related Issues
CR Description Workaround
6551509 If you run
modunload
while the
nxge
port is
running, a system panic might occur.
Note - Fixed in the Solaris 10 5/08 OS (and
later) and in the Solaris 10 8/07 OS with patch
ID 127127-11 or later installed.
Unplumb the interfaces prior to unloading the
driver. See
“Using
modunload
While the
nxge
Port Is Running, Could Cause a System Panic
(CR 6551509)” on page 76
.
You can also upgrade the OS or install the patch
to avoid encountering this issue.
6554478 Receiving Jumbo Frames might drop the
Ethernet interface to 30 Mbps due to packet
dropping. Note - Fixed in the Solaris 10 5/08 OS (and
later) and in the Solaris 10 8/07 OS with patch
ID 127127-11 or later installed.
Set the MTU size to 8172 as described in “Jumbo
Frames Throughput of
nxge
Drops to 30 Mbps
Due to Packet Dropping (CR 6554478)” on
page 78
.
You can also upgrade the OS or install the patch
to avoid encountering this issue.
6561389 Setting properties for the network interface unit
(NIU)
nxge
devices could fail.
For an example of the failure, see “Setting
Properties for
nxge
Devices Might Fail (CR
6561389)” on page 80 .
Note - Fixed in the Solaris 10 5/08 OS (and
later) and in the Solaris 10 8/07 OS with patch
ID 127127-11 or later installed.
Use the global declaration without the device
path in the
nxge.conf
file. For example, add
the following line to the
nxge.conf
file:
accept_jumbo = 1;
You can also upgrade the OS or install the patch
to avoid encountering this issue.