2
Figure 2. Silicone Sleeve - Back
Figure 3. Laying in System
Web Camera
Fingerprint
Sensor Opening
Pen Holder
Opening
Threaded insert holes (for use with optional hand strap)
g
Страница 1: ...stem is installed correctly please perform the following steps 1 Align the system above the sleeve so that the fingerprint sen sor and web camera opening are aligned with those features on the back of the tablet Figure 2 2 Tuck one of the narrow ends of the system into the sleeve under the flexible edge Figure 3 Lay the other end of the system atop the other end of the sleeve 3 Due to the secure f...
Страница 2: ...2 Figure 2 Silicone Sleeve Back Figure 3 Laying in System Web Camera Fingerprint Sensor Opening Pen Holder Opening Threaded insert holes for use with optional hand strap g ...
Страница 3: ...e sleeve To install run the loop on the end of the tether or lanyard through the pen tether attachment point then feed the pen or lanyard through the loop Pull it taut Optional Hand Strap An optional hand strap is available as an accessory When the system is installed in the silicone sleeve the hand strap can be attached to the threaded inserts through the holes in the back of the sleeve Figure 2 ...
Страница 4: ...011 Fujitsu America Inc All rights reserved To attach it to the docking cradle visually align the connector on the bottom of your slate with the connector on the docking cradle Fig 5 While holding the top away from the cradle set the slate onto the cradle with the connec tors aligned To protect your system from damage during doc king do not push too hard or the connectors may be damaged Lay the to...
