Fujitsu Remote Control, Руководство по эксплуатации, Страница: 3 / 13

En-2
F
1
2
7
4
5
6
8
9
0
A
C
D
3
B
E
Display
NAME OF PARTS
Display panel
To facilitate explanation, the accompanying illustration
has been drawn to show all possible indicators; in ac-
tual operation, however, the display will only show those
indicators appropriate to the current operation.
1
MODE button
2
ECONOMY button
3
SET TEMP. button ( / )
4
FILTER RESET button
5
SLEEP button
6
FAN button
7
START/STOP button
8
SET button (Vertical)
9
SET button (Horizontal)
0
SWING button
A
TIMER MODE button
B
TIMER SET ( / ) button
C
CLOCK ADJUST button
D
RESET button
E
TEST RUN button
●
This button is used when installing the condi-
tioner, and should not be used under normal
conditions, as it will cause the air condition-
er’s thermostat function to operate incorrectly.
●
If this button is pressed during normal opera-
tion, the unit will switch to test operation
mode, and the Indoor Unit’s OPERATION In-
dicator Lamp and TIMER Indicator Lamp will
begin to flash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
F
Signal Transmitter
G
Temperature SET Display
H
ECONOMY Display
I
Operating Mode Display
J
SLEEP Display
K
Transmit Indicator
L
Fan Speed Display
M
SWING Display
N
Timer Mode Display
O
Clock Display
Some indoor units may not be equipped with the func-
tions corresponding to all of the buttons on this remote
controller. The indoor unit will beep and the OPERATION,
TIMER and FILTER lamp flash when a remote controller
button is pressed if the function is not available.
L
N
O
M
K H
G
I
J