Fujitsu Primergy RX600 S2, Руководство пользователя

Страница: 200 / 299

200
Chapter 7 Installing Internal Options
7.4.5 Defective Memory Disconnection Function
This server is equipped with a defective memory disconnection function.
This function disconnects the memory judged to be defective (abnormal) during Power On Self Test
(POST) to start the server. When POST is executed, if the memory capacity is discovered to be smaller
than the capacity of the memory installed, there is a possibility of memory defect.
You can check the slot whose memory is defective from the system event log.
Replacing the Defective Memory
Replace the defective memory module with a new one, referring to "7.4.4 How to Install Memory
Modules" ( pg.197).
After replacing the memory module, start the BIOS Setup Utility, select the [Configure System RAS
and Performance] submenu from the [Memory] menu, and change the [Retest All System Memory]
setting from [Disabled] to [Enabled]. Setting the item to [Enabled] releases the failed memory status at
the next startup and enables the use of the new memory module.
To confirm whether the status is released, start the BIOS Setup Utility, select the [Memory] menu
→
[View and Configure Memory Board n] ("n" represents the memory board number), and press the
[Enter] key. Check that [Board Status] is [Healthy].
For details on the BIOS Setup Utility, refer to "8.3 BIOS Setup Utility" ( pg.237).
7.4.6 How to Replace Memory Modules under Hot-plug
Support
The memory boards of this server are hot-pluggable, when using the memory mirroring function or
memory RAID function. The memory modules can be replaced without turning off the server. Follow
the following procedure.
If memory modules need to be replaced while the server is running, always contact your maintenance
engineer to replace them.
1
Check the location of the memory board and slot of the defective memory.
2
Remove the top cover without turning off the server.
"7.2 Removing and Attaching the Top Cover" (pg.180)
3
Touch a metal part of the server to discharge static electricity.
• When sliding the server out of the rack, make sure that the cables on
the backside, such as the power cable, are not unplugged or become
entangled.
• Do not touch other devices inside the server.