Fujitsu PRIMERGY RX1330 M3, Руководство по эксплуатации

Страница: 48 / 84

48 Operating Manual
RX1330 M3
Hardware installation
5.1 Unpacking the server
V
CAUTION!
Follow the safety instructions in "Important information" on page 33 .
The server must always be lifted or carried by at least two people.
For Japan:
Please refer to "
安全上のご注意
".
Do not unpack the server until it is at its installation location.
Ê
Transport the server to the place where you want to set it up.
Ê
Unpack all individual parts.
Keep the original packaging in case you want to transport the server again
(does not apply to Japan).
Ê
Check the delivery for any damage during transport.
Ê
Check whether the items delivered match the details on the delivery note.
The product name and serial number of the product can be found on the ID card
(see section
"ID card" on page 70 ).
Ê
Notify your supplier immediately should you discover that the items
delivered do not correspond to the delivery note.
5.2 Installing/removing the server in/from the
rack
V
CAUTION!
●
Please observe the safety information and notes on rack mounting in
chapter
"Important information" on page 33 and section "Notes on
installing the server in the rack" on page 44 .
●
At least two people are needed to install / remove the server in the
rack. (For Japan, please refer to "
安全上のご注意 ".)
●
Do not extend more than one unit out of the rack simultaneously even
if the tilt protection is in place. If several units are simultaneously
extended out of the rack, there is a risk that the rack could tip over.