Fujitsu MB2198-701-E, Руководство по эксплуатации

Страница: 8 / 16

4
4. Procedure for Connecting to the User System
Mount the supplied NQPACK on the user system before using the header board.
■
Connection Procedure
1. To connect the header board to the user system, align the index mark (
▲
) on the header board
with pin 1 on the NQPACK mounted on the user system, which is also indicated by an index
mark (
▲
), and insert the header into the NQPACK (See Figure 3).
As the YQPACK pins are thin and easily bent, check that the YQPACK pins are kept straight
when inserting into the NQPACK.
2. Insert the header board attachment screws, together with washers, into the four screw holes in the
top of the header board and tighten the diagonally opposite screws in turn (See Figure 4).
Use the dedicated screwdriver supplied with the NQPACK to tighten the screws equally.
Take care not to over-tighten as this may cause a bad connection.
Figure 3 Index positions
NQPACK
index (
▲
)
Header board
index (
▲
)
YQPACK
(Mounted on the rear surface)
Flat cable connector A
Flat cable connector B