Fujitsu l2010, Руководство пользователя

Страница: 75 / 106

59
SECTION 1
Item
Status (connected • not yet connected
• Disable Radio, etc.)
Network name (SSID)
BSSID
Data encryption (WEP)
Speed (transmission)
Channel
Client IP Address
Network Connection Type
Radio state
Signal
Noise
Comment
Connection condition, radio wave transmission
condition, etc. are shown.
Inputted network name (SSID) is shown.
In the infrastructure connection, the MAC address of
the station currently in connection is shown. In the ad
hoc connection, the value is shown also but it is not the
MAC address of the client in the ad hoc connection.
When the network key is used, “Enabled” appears in
this line. When the network key is not use, “Disabled”
appears.
The present transmission rate is shown in Mbps. No
reception rate is shown.
The channel currently in use for communication is
shown.
The IP address is shown.
“Infrastructure” or “ad hoc” is shown.
When radio wave is outputted, “Enable Radio” appears.
The longer the indication of the bar graph is, the better
the radio wave condition is.
The shorter the indication of the bar graph is, the better
the radio wave condition is under a little influence of
noise.
When you fail in connection with the network or want to confirm the connection, refer to the
“Troubleshooting”.
3. Check the radio wave condition on the “Link Status” tab page.
The present connection condition is shown.
When radio wave is turned off or the computer is not yet connected, connection condition is
not shown for some items.
Egmont Sec 1(46-59) 30/5/03, 9:14 AM 59