Fujitsu IRF-1D series, Руководство пользователя

Страница: 159 / 182

Chapter 6 - Maintenance
Replacing the SES Controller Card
147
Replacing the SES Controller Card
WARNING:
The SES Controller Card is NOT HOT-SWAPPABLE. You must
POWER DOWN the storage enclosure to remove or install this card.
1
Power down the storage enclosure, refer to “Powering Off the Storage
System” on page 107.
2
Using a flat-blade screwdriver, loosen the two captive fastener screws that
secure the card.
3
Note the positions of the switch settings.
4 Using the captive fastener screws, gently pull the card from the enclosure.
5
Remove the new replacement card from the shipping container and inspect
for obvious damage. Save the packaging materials.
SES Controller Card Switches
6
Set the switch settings on the replacement card to match those of the faulty
card.
7
Insert the replacement card by aligning it into the rail guides and push the
card until it fully seats.
Tighten the two captive fastener screws. Do not overtighten the screws.
8
Power-on the enclosure. Refer to “Powering On the Storage System” on
page 107.
9
Using the packaging materials from the replacement card, repackage the
failed card and return it per your RMA instructions.
SES
RS-232
A
D
0
A
D
1
1 2
Up position
Down position
3 4 5 6 7 8
A
D
2
S
P
1
S
P
2
B
D
R D
L
Y
R
M
T
imageRAID.book Page 147 Tuesday, September 23, 2003 4:08 PM