Fujitsu IP-900D, Руководство пользователя по оборудованию, Страница: 63 / 116

Chapter 3 Operation Instructions
IP-900E/IP-900D/IP-900IID
49
3.3
Special Use of MNT Button
You can start IP-900E/IP-900D/IP-900IID by turning on the power while holding down the
[MNT] Button (for about 10 seconds) until the RDY LED begins blinking in orange. Doing so
starts the IP-900E/IP-900D/IP-900IID with the initial IP address and subnet mask with which the
IP-900E/IP-900D/IP-900IID is shipped from the factory (IP address 10.0.0.1, Subnet mask:
255.0.0.0).
Use this function when making initial settings for IP-900E/IP-900D/IP-900IID from a control
terminal (such as a PC having a LAN interface) (*1).
*1 When you operate the IP-900E/IP-900D/IP-900IID with the default IP address, connect this
equipment to a control terminal and make setting from the terminal with this equipment
disconnected from your network.
After making settings according to the requirements for your network, connect this
equipment to the network. If this equipment with the default settings made at the factory is
connected to the network, an unexpected problem may occur with your network.
If you start IP-900E/IP-900D/IP-900IID while holding the [MNT] button, set the IP
addresses and subnet masks of the control terminal to connect as follows:
- IP address : 10.xxx.xxx.xxx
(xxx is any number from 0 to 255, excluding 10.0.0.0, 10.0.0.1, and 10.255.255.255.)
- Subnet mask : 255.0.0.0
3.3