Fujitsu Inverter Halcyon AOU12RL, Руководство по эксплуатации

Страница: 13 / 19

En-12
SWING OPERATION
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 a-2) for three sec-
onds on the main unit control panel.
To stop operation, press the MANUAL AUTO button (Fig. 2 a-2) for three seconds.
●
When the air conditioner is operated
by the controls on the Main Unit, it will
operate under the same mode as the
AUTO mode selected on the Remote
Control Unit (see page 6).
●
The fan speed selected will be “AUTO”
and the thermostat setting will be
standard (76
°F
).
COIL DRY OPERATION
The Indoor unit can be dried by pressing the COIL DRY button on the Remote Control Unit so as to avoid going moldy and
restrain the breed of bacterium.
The COIL DRY operation will operate for 90 minutes after pressing the COIL DRY button and it will stop automatically.
To select COIL DRY Operation
Press the COIL DRY button (Fig. 6 b-5) during operation or when
it stops.
The COIL DRY Display (Fig. 7 c-10) will light. Then, it will disappear after 10 seconds.
To cancel COIL DRY Operation
Press the START/STOP button (Fig. 6 b-9) during COIL DRY
Operation.
The indoor unit COIL DRY Indicator Lamp (yellow) (Fig.1 a-7) will go out. Then, the
operation stops.
About COIL DRY Operation
●
Press the COIL DRY button again during COIL DRY Operation, COIL DRY Opera-
tion can be reset.
●
The COIL DRY Operation cannot get rid of the existed mold or bacterium, and it
has no sterilization effect either.
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 6 b-12).
The SWING Display (Fig. 7 c-4) will light.
In this mode, the Air Flow Direction Louvers will swing automatically to direct the
air flow both up and down.
To stop SWING Operation
Press the SWING button (Fig. 6 b-12) once again.
The SWING Display (Fig. 7 c-4) will go out.
Airflow direction will return to the setting before swing was begun.
About Swing Operation
During cooling/Dry mode : Swings between 1 and 3.
During heating mode
: Swings between 3 and 6.
●
The SWING operation may stop temporarily when the air conditioner’s fan is not
operating, or when operating at very low speeds.