Fujitsu Inverter AOTR07JEC, Руководство по эксплуатации

Страница: 12 / 16

CLEANING AND CARE
●
Before cleaning the indoor unit, be sure to turn it off and disconnect the Power Supply Cord.
●
Be sure the Intake Grille (Fig. 1
8
) is installed securely.
●
When removing or replacing the air filters, be sure not to touch the heat exchanger, as personal
injury may result.
CAUTION!
Cleaning the Intake Grille
1. Remove the Intake Grille.
1
Place your fingers at both lower ends of the grille
panel, and lift forward; if the grille seems to catch
partway through its movement, continue lifting up-
ward to remove.
2
Pull past the intermediate catch and open the Intake
Grille wide so that it become horizontal.
2. Clean with water.
Remove dust with a vacuum cleaner; wipe the indoor
unit with warm water, then dry with a clean, soft cloth.
3. Replace the Intake Grille.
1
Pull the knobs all the way.
2
Hold the grille horizontal and set the left and right
mounting shafts into the bearings at the top of the
panel.
3
Press the place where the arrow on the diagram indi-
cates and close the Intake Grille.
Cleaning the Air Filter
1. Open the Intake Grille, and remove the air
filter.
Lift up the air filter’s handle, disconnect the two lower
tabs, and pull out.
2. Remove dust with a vacuum cleaner or by
washing.
After washing, allow to dry thoroughly in a shaded place.
3. Replace the Air Filter and close the Intake
Grille.
1
Align the sides of the air filter with the panel, and push
in fully, making sure the two lower tabs are returned
properly to their holes in the panel.
2
Close the Intake Grille.
(For purposes of example, the illustration shows the indoor
unit without Intake Grille installed.)
●
Dust can be cleaned from the air filter either with a vacuum
cleaner, or by washing the filter in a solution of neutral
detergent and warm water. If you wash the filter, be sure
to allow it to dry thoroughly in a shady place before rein-
stalling.
●
If dust is allowed to accumulate on the air filter, airflow
will be reduced, lowering operating efficiency and increas-
ing noise.
●
During periods of normal use, the Air Filters should be
cleaned every two weeks.
●
Don't operate the air conditioner with being opened the
intake grille.
●
When used for extended periods, the indoor unit may accumulate dust inside, reducing its performance. We recommend
that the indoor unit be inspected regularly, in addition to your own cleaning and care. For more information, consult
authorized service personnel.
●
When cleaning the indoor unit’s body, do not use water hotter than 40 °C, harsh abrasive cleansers, or volatile agents like
benzene or thinner.
●
Do not expose the indoor unit’s body to liquid insecticides or hairsprays.
●
When shutting down the indoor unit for one month or more, first allow the fan mode to operate continuously for about
one-half day to allow internal parts to dry thoroughly.
Intake Grille
Air filter handle
Air filter (Right & Left)
Mounting
shaft
Bearing
Knob
Mounting
shaft
Knob
1
2
3
1
2
3
Hooks(two places)
Hooks(two places)
En-11
08H307_9317433068_En 2008.8.29, 13:22 12