Chapter 1 Scanner Overview
35
This section explains about the basic flow of performing a
scan.
In order to perform a scan, you need a scanner driver and an
image scanning application that supports the scanner driver.
The following scanner drivers and image scanning
applications are bundled with the scanner:
Scanner driver
- PaperStream IP (TWAIN)
Conforms to the TWAIN standard. Used when you operate the
scanner using TWAIN-compliant 32-bit applications.
- PaperStream IP (TWAIN x64)
Conforms to the TWAIN standard. Used when you operate the
scanner using TWAIN-compliant 64-bit applications.
- PaperStream IP (ISIS) for fi-71xx/72xx
Conforms to the ISIS standard. Used when you operate the
scanner using ISIS-compliant applications.
Image scanning application
- PaperStream Capture
An image scanning application which supports both
PaperStream IP (TWAIN) and PaperStream IP (ISIS) for fi-71xx/
72xx. By defining scan settings as document profiles, you can
customize the settings according to your preference.
- ScanSnap Manager for fi Series
An image scanning application which uses the scan settings
dedicated to ScanSnap Manager for fi Series. PaperStream IP
(TWAIN) is required for this application. Using this application
makes it easy to create an image file (a PDF, JPG, or
searchable PDF file) with a single button.
The following describes the normal procedure for scanning.
1
Turn on the scanner.
For details, refer to
"1.3 Turning the Power ON/OFF" (page 23)
2
Load the documents in the ADF paper chute (feeder).
Load a document face-down in the ADF paper chute (feeder).
For details, refer to
"Chapter 2 How to Load Documents" (page 37)
.
3
Start an image scanning application.
4
Select a scanner driver.
For some image scanning applications, selection of a scanner driver
may not be needed.
1.9 Basic Flow of Scanning Operation
HINT
For details about the scanner driver, refer to the PaperStream IP
driver Help.
For details about the image scanning applications, refer to the image
scanning application manual.
