Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
550
Copyright 2011 FUJITSU LIMITED
P2X0-1090-02ENZ0
11.2.7
Event/Dump Management
This section describes event/dump management.
Event/dump management provides the following functions:
•
•
•
•
•
Start/Stop Performance Monitoring
11.2.7.1
Setup Event Notification
This function specifies whether to report events that are detected in the ETERNUS DX Disk stor-
age system.
There are five methods for event notification: Host Sense, SNMP Trap, E-Mail, syslog and
REMCS.
A notification setting can be selected for each type of event.
The procedure to set the event notification is as follows:
Procedure
1
Click [Setup Event Notification] in [Action].
2
Specify whether to notify each event, and click the [Set] button.
•
For SNMP Trap notification, performing procedures in
SNMP Agent Basic Interface" (page 464)
"11.2.3.5 Setup SNMP Agent MIB Access View"
,
"11.2.3.6 Setup SNMP Agent User" (page 471)
Setup SNMP Agent Community" (page 474)
, and
is required.
•
For E-Mail notification, performing procedure in
is required.
•
For syslog notification, performing procedure in
is required.
•
For REMCS notification, performing procedure in
is required.
When selecting REMCS for event notification, only the REC related error
event settings can be changed.
The events are classified into three levels: "Error Severity Level",
"Warning Level", and "Informational Level".
Click the [Setting based on Severity] tab, [Error Severity Level] tab,
[Warning Level] tab or [Informational Level] tab to display the setting
fields for each level.