Fujitsu ETERNUS DX400 series, Руководство по настройке

Страница: 9 / 17

Chapter 2 ETERNUS DX Connection Settings
2.1 Common Settings
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2014 FUJITSU LIMITED P3AM-3972-08ENZ0
9
2.1.2 Sense Data Conversion (Setting the Host Responses)
The ETERNUS DX host responses must be set to match the way in which the server will process the ETERNUS DX
request responses.
These are different for each OS and this must be done before connecting the ETERNUS DX to the server.
Retain the default values for all parameters not described below.
2.1.2.1 Solaris OS
For Solaris OS, perform the settings detailed in
Table 2.2
and Table 2.3 .
Table 2.2 Reservation Conflict Response for Test Unit Ready setting for Solaris OS
Table 2.3 Sense Data Conversion Pattern setting for Solaris OS
2.1.2.2 HP-UX
For HP-UX, set the [Host Specific Mode] to [HP-UX Mode (SCC)].
Table 2.4 Host Specific Mode setting for HP-UX
Reset Scope I_T_L (Default value)
Reserve Cancel at Chip Reset OFF (Default value)
Header Digest OFF (Default value)
Data Digest OFF
(Default value)
Parameter Solaris OS, HP-UX, Windows®, Linux, VMware ESX, Oracle VM Server
OS
MPxIO (OS standard Multipath Driver)
Used Not used
Solaris 10 OS Conflict Response Normal Response (Default)
OS
[Sense Data Conversion Pattern]
setting
Solaris 10 OS
Linux Recommended
(When not using GRMPD)
OS [Host Specific Mode] setting
HP-UX HP-UX Mode (SCC)