Fujitsu ETERNUS DX400 series, Руководство по настройке

Страница: 13 / 17

Chapter 2 ETERNUS DX Connection Settings
2.1 Common Settings
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2014 FUJITSU LIMITED P3AM-3972-08ENZ0
13
2.1.5 Creating and Allocating LUN Groups (Setting Host Affinity Groups)
Define the relationship between the server to be connected to the iSCSI port of the ETERNUS DX and the
created Affinity Group. This sets access restrictions to the ETERNUS DX from each server.
See "Allocate Host-Affinity Group" of "ETERNUSmgr User Guide" for details.
2.1.6 Setting CHAP Authentication
The ETERNUS DX supports the use of CHAP authentication. This section describes the procedure for setting
CHAP authentication in the ETERNUS DX. This setting can be omitted.
Procedure
1
Click the [Setup iSCSI Host] under the [Host I/F Management] menu.
• When setting a LUN that has the same configuration for multiple iSCSI paths for recognition, define the
same Affinity Group.
• If the one-to-one relationship between IP addresses and LAN cards cannot be determined, the Host
Affinity Group settings may not be performed correctly.
In this case, trying various settings may be necessary until the server is able to recognize the ETERNUS DX
logical disks.
To set CHAP authentication, set "CHAP" to "ON" in advance according to "2.1.1 Setting the To-server
Connection Type (Setting the CA Parameters)" (page 8) . To set bidirectional CHAP authentication, specify a
user name and password for the iSCSI port in advance.
If an iSNS server with the server iSCSI name registered does not exist in the network, [Add New iSCSI
Host] cannot be used.
When the iSNS server does not exist, enter the server iSCSI information manually.