Fujitsu ETERNUS DX400 series, Руководство по настройке

Страница: 8 / 17

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2014 FUJITSU LIMITED P3AM-3972-08ENZ0
8
Chapter 2
ETERNUS DX Connection Settings
2.1 Common Settings
This section explains the settings required for all server OSs, regardless of the connection configuration. For
details of how to use ETERNUSmgr to perform these settings, refer to the "ETERNUSmgr User Guide".
2.1.1 Setting the To-server Connection Type (Setting the CA Parameters)
For each connection configuration, perform the following iSCSI port parameter settings only. All other
parameters should be left on their default values.
Table 2.1 CA parameter settings (iSCSI port settings)
Parameter Solaris OS, HP-UX, Windows®, Linux, VMware ESX, Oracle VM Server
TCP/IP Setting
IP Address Arbitrary
Subnet Mask Arbitrary
Gateway Arbitrary
iSNS Server Select "ON" to use the iSNS server, and specify the IP address for the iSNS
server.
iSCSI Settings
iSCSI Name Arbitrary
Caution:
When configuring multipaths, specify a different name for each iSCSI port.
If the same iSCSI name is specified for multiple ports, connection via
multipaths may not be available.
Alias Name Arbitrary
Security
CHAP OFF (Default value): When both unidirectional CHAP authentication and
bidirectional CHAP authentication are not used
ON: When either unidirectional CHAP authentication or bidirectional CHAP
authentication is used
User Name When using bidirectional CHAP authentication, set a password.
When using unidirectional CHAP authentication, a CHAP user name and
password do not need to be set.
New Password
New Password (Re-enter)
General Settings
Affinity Mode
OFF (Default value): When not using Affinity Mode
ON: When using Affinity Mode
Host Affinity ON
Host Response Not available ( When "Host Affinity" is set to "ON")