Fujitsu D1271, Техническое руководство

Страница: 41 / 79

D1271/D1291 CUV-LSV/CUV-LV User’s Manual 37
3. HARDWARE SETUP
Connectors
3. H/W SETUP
9) Standard Infrared Module Connector (5-pin IR)
This connector supports an optional wireless transmitting and receiving infrared
module. This module mounts to a small opening on system cases that support
this feature. You must also configure the setting through UART2 Use Infrared
(see 4.4.2 I/O Device Configuration) to select whether UART2 is directed for
use with COM2 or IrDA. Use the five pins as shown in Back View and connect
a ribbon cable from the module to the motherboard SIR connector according to
the pin definitions.
10) Chassis Intrusion Lead (2-pin CHASSIS)
This lead is for a chassis designed for chassis intrusion detection. This requires
an external detection mechanism such as a chassis intrusion monitor/sensor or
microswitch. When any chassis component is removed, the sensor is triggered
and a high-level signal is sent to this lead to record a chassis intrusion event.The
event is then be processed by software such as LDCM. When not using the
chassis intrusion lead, place a jumper cap over the pins to close the circuit.
CUV-LSV
CUV-LSV Infrared Module Connector
Front View Back View
+5V IRTX
IRRX
(NC)
GND
+5V
IRRX IR
TX
(NC)
GND
IR
1
CUV-LSV Chassis Open Alarm Lead
CHASSIS
CUV-LSV