2
Installing the notebook
Figure 2. Bump case - Rear
To install your notebook into the bump case:
1.
Be sure your notebook is in tablet mode
(i.e., with the display
facing out). For instructions on putting the notebook into
tablet mode, please see your system user’s guide.
2.
Open the flap on the rear of the case
(Figure 2)
. The flap is
secured by a long strip of Velcro® that is attached to the back
of the bump case.
3.
Position the notebook so that the system goes into the case
with the battery going in last. Slide the notebook all the way
into the bump case until it meets the opposite end of the case.
4.
Reattach the flap to the side of the case.
Prior to installing the notebook into the bump
case, remove the pen. Once the system is
installed, you will not be able to remove the
pen. Store the pen in the pen holder. (Figure 1)
Flap
Hand Strap
B5FY-8311-01EN-00 Bump Case.fm Page 2 Thursday, August 23, 2007 2:35 PM
