![background image](http://html.mh-extra.com/html/fujitsu/b23q8wd-g-01-j/b23q8wd-g-01-j_hardware-manual_120932017.webp)
11
z
For 1000Mbps, disabling auto-negotiation is not supported.
4.6 Support of JumboFrame for on-board network
interface(bge) on SPARC Enterprise T1000 server
(Solaris 10 OS 11/06 only)
The configuration of Jumbo frames is not supported for port 0 and port 1 (bge0 and bge1) that are on-board
network interfaces on SPARC Enterprise T1000 server.
However, the configuration of Jumbo frames is supported for port 2 and port 3 (bge2 and bge3).
4.7 Notes on using the Standard Solaris Fibre Channel
Driver
Several notes on using the standard Solaris fibre channel driver are described in this section.
z
Target Host Bus Adaptor
-
XSEFC401AF
-
XSEFC402AF
-
XSEFC401AU
-
XSEFC402AU
4.7.1 I/O Performance
Due to Solaris specification, sufficient read performance may not be achieved when 4Gbps supported disk
array unit is connected.
Reference values *
Write performance: Approximately 365Mbyte/sec
Read performance:
Approximately 180Mbyte/sec
* These are actual values measured by Fujitsu. Note that the values may differ depending on the system
configuration.
4.7.2 Multi-host Connection
When two or more hosts are connected to a single disk array (fibre channel switch connection), following
caution must be observed.
z
Connection of two or more hosts in the same zone is not supported. Zone must be divided using the
Port Zoning feature of the fibre channel switch.