4
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
3
Remote Control Signal Receiver
4
Indicator Lamps (Fig. 3)
5
OPERATION Indicator Lamp
(green ...... COOL, DRY, FAN)
(red .......... *HEAT)
6
TIMER Indicator Lamp (yellow)
7
SWING Indicator Lamp (orange)
(VERTICAL/HORIZONTAL SWING)
8
AIR CLEAN Indicator Lamp (green)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See page 19 Auto Restart).
9
Intake Filter (Fig. 4)
;
UP/DOWN Air Direction Flaps
A
RIGHT/LEFT Air Direction Louvers
(behind UP/DOWN Air Direction Flaps)
B
Drain Hose
C
Electronic Air Clean Unit (Fig. 4)
Fig. 5 Outdoor Unit
D
Intake Port
E
Outlet Port
F
Pipe Unit
Fig. 6 Remote Control Unit
G
AIR CLEAN button
H
MASTER CONTROL button
I
SET TEMP./SET TIME buttons (
)
J
Signal Transmitter
K
TIMER button
L
FAN CONTROL button
M
START/STOP button
N
AIR FLOW DIRECTION
VERTICAL SET button
O
AIR FLOW DIRECTION
VERTICAL SWING button
P
AIR FLOW DIRECTION
HORIZONTAL SET button
Q
AIR FLOW DIRECTION
HORIZONTAL SWING button
R
TIME ADJUST button
S
ACL button
Rear side (Fig. 7)
T
TEST RUN
●
Touch the two metal contacts with a me-
tallic object to send the signal to perform
a test run.
●
Perform a test run only when installing the
air conditioner. If the signal to perform a
test run is received during normal opera-
tion, the air conditioner’s thermostat will
malfunction.
●
If the signal to perform a test run is re-
ceived during normal operation, the unit
will switch to the test operation mode and
the indoor unit’s OPERATION and TIMER
indicator lamps will flash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
U
Remote Control Unit Display (Fig. 8)
V
Transmit Indicator
W
Clock Display
X
Operating Mode Display
Y
T imer Mode Display
Z
Fan Speed Display
[
Temperature Set Display
\
T imer Set Indicator
]
Temperature Set Indicator
