background image

En-5

 5. TIMER OPERATIONS

NOTES: 

When [   ] indicator on the indoor unit blinks, set the clock 

and timer again. This blinking shows that the internal clock go 
wrong due to an interruption of the power supply. (Refer to 
page 7.)

 5.1. On timer or Off  timer

The On timer starts the operation at your desired time.

The Off  timer stops the operation at your desired time.

1.

When you use the On timer, press

.

When you use the Off  timer, press

.

2.

Each time you press the button, the time changes as follows:

hours

0.5

1.0

1.5

2.0

...

9.5

10

11

12

• When you use the On timer, set the time while the   indicator on

the remote controller display is blinking.

• When you use the Off  timer, set the time while the   indicator on the

remote controller display is blinking.

• To deactivate the On/Off  timer, press 

 while [ ] or [ ]

is shown on the remote controller display.
The indicator will disappear.

5.2. Program timer

The Program timer operates as the combination of the On timer and Off  
timer.

)

Set On timer and Off  timer. (Refer to "5.1. On timer or Off  

timer").

First, the timer set earlier will operate. 
After the time set by the earlier timer passed, the timer set later will 
begin the counting down.

Timer

Indicator on the remote controller display

On→Off  timer

Off →On timer

NOTES:

  If you change the setting value for the timer after the Program 

timer is set, the counting down of the timer will be reset at that 
moment.

 5.3. Sleep timer 

The Sleep timer supports your comfortable sleep by moderating the air 
conditioner operation gradually.

)

Press 

.

Each time you press the button, the time changes as follows:

1.0

2.0

3.0

5.0

7.0

CANCEL

hours

9.0

• Set the time while the

 indicator on the remote controller display 

is blinking.
To repeat the timer, press the button when the indicator is not 
displayed.

During the Sleep timer operation, the setting temperature changes as 
the following fi gure.

In Heating mode

Set
temperature

Set time

1 hour

Set time

1 hour

1.5 hour

30 min.

1 °C 2 °C 3 °C 4 °C

2 °C

1 °C

In Cooling or Dry mode

After the set time has elapsed, the air conditioner operation turns off .

 6. ENERGY SAVING OPERATIONS

6.1. Economy operation

It saves more electricity than other operation modes by changing the set 
temperature to a moderate setting.

)

Press 

 to activate/deactivate the Economy 

operation.

[   ] indicator on the indoor unit will turn on.

Operation 

mode

Room temperature

Cooling/Dry

Few degrees higher than the set temperature

Heating

Few degrees lower than the set temperature

NOTES:

• In the Cooling, Heating, or Dry mode, the maximum output of this

operation is approximately 70 % of usual operation.

• This operation cannot be performed during the temperature

monitoring by the Auto mode.

7. OTHER OPERATIONS

 7.1. Powerful operation

In the Powerful operation, the air conditioner will operate at maximum 
power and strong airfl ow to cool down or warm up the room quickly.

)

Press 

 to activate/deactivate the Powerful operation.

When activated, the indoor unit will emit 3 short beeps.
When deactivated, the indoor unit will emit 2 short beeps.

The Powerful operation will be turned off  automatically in the following 
situations:

• The Powerful operation runs for a certain amount of time and the

room temperature reaches the set temperature in the Cooling, Dry,
or Heating mode.

• 20 minutes after the Powerful operation has started.

NOTES:

• The airfl ow direction and the fan speed are controlled automatically.
• The Powerful operation cannot be performed simultaneously with

Economy operation.

8. CLEANING AND CARE

CAUTION

• Before cleaning this product, be sure to turn it off  and

disconnect all the power supply.

• Before starting operation, make sure that the intake

grille has been shut completely. Incomplete closing

of the intake grille might have an eff ect on the proper

working or performance of the air conditioner.

• If the fi lter cleaning involves high-place work, please

consult the authorized service personnel.

• Do not touch the aluminum fi ns of heat exchanger

built-in the indoor unit to avoid personal injury when

you maintain the unit.

• Do not expose the indoor unit to liquid insecticides or

hair sprays.

• Do not stand on slippery, uneven or unstable surfaces

when you maintain the unit.

9333892009_OM.indb   5

9333892009_OM.indb   5

12/21/2018   2:34:04 PM

12/21/2018   2:34:04 PM

Содержание ASYG07-09-12KPCA










Отзывы: